Most PG governors head by a ring bolt (lug) hoisting, turbine controller, the ring head bolts (lug) is mounted in the center of a governor cover 0.375-16 (inch) hole. PG-200, PG-300, PG-500 governor must use derrick hoisting grommet. Some PG governor detachable cover, turbine control prices, but also need to use the derrick hoisting grommet. Between the governor and the accessory mount to use a spacer. Recommend shim 0.032 inches thick (0.81mm). Spacer used to fill not fit between the governor base and mount between the turbine controller company, avoiding oil between the driving part of the governor an engine leak. In the normal operating state of the vehicle, all OH1.2 system diagnostics will continue to run. Fault codes can be read fault indicator or laptop, the reference manual "with a laptop and diagnostic jumpers OH1.2 system diagnostics." For the system to clear fault codes, can be a laptop or the ignition key switch to "OFF", and disconnect OH1.2 total electrical safety system clears 15 seconds. Shenyang turbine controller _ _ Empire turbine controller automation equipment provided by the Shenyang Automation Equipment Co., Ltd. Empire. "Automation control equipment, machinery and equipment, electronic equipment development and design" preferred Empire Shenyang Automation Equipment Co., Ltd. (www.syepe.net), the company is located: Tiexi District of Shenyang Xinghua North Street 18 A 1404, over the years, Shenyang TU Pyle Automation Equipment Co., Ltd. to provide customers with the best quality service, contact: Lien Ning. Welcome to the new and old customers call, letter, visit the guide, business negotiations. Empire Shenyang Automation Equipment Co. expect to be your long-term partner!